Z-Wave
W1-B/C W3-B/C
Please see the attachments in the this articles
Z-Wave Lock - How to change a Motor
Step # 1: unscrew all the screws as shown Step # 2: Take the old motor off as shown Step # 3: Plug in the new motor as shown Step # 4: Finally put all the screws back and tighten them.
Z-Wave Lock - Optimal polling interval for the control module
Manufacturer recommends maximum polling interval during setup of the lock device: 10800s polling This will minimise the time the lock connects to the Z-wave module and maximum the lock battery performance.
AKE-100/AKE-300 Setup Tips – Getting Started
Key Tips: Default management mode code: 888888 Flashing RED LED is the normal mode. Solid RED LED is the management mode. Green LED flashes and relay fires when code/card is correct (or REX button grounded) Follow the below setups to get up and ...
Z-Wave - How to add a User Pin Code
Z-Wave - Weather Rating
Yes, the KAS Z-wave digital lock can be used as an external door lock. It cannot be exposed to direct rain/wet weather. It can be installed on an outside door provided it has adequate partial or full cover so water does not leak into the keypad. The ...
Z-Wave Lock - Where To Buy
Where can I buy Z-wave Lock? This product is no longer purchasable in the KAS product line. We will still support this product to other certified Z-wave resellers. You can connect them here… www.digitalhomesystems.com.au
Z-Wave - How to Factory Reset