Z-Wave Lock - How to change a Motor

Step # 1:

unscrew all the screws as shown

Step # 2:

Take the old motor off as shown

Step # 3:

Plug in the new motor as shown

Step # 4:

Finally put all the screws back and tighten them.

• Related Articles

• Z-Wave Lock - Where To Buy

  Where can I buy Z-wave Lock? This product is no longer purchasable in the KAS product line. We will still support this product to other certified Z-wave resellers. You can connect them here… www.digitalhomesystems.com.au

• Z-Wave - Weather Rating

  Yes, the KAS Z-wave digital lock can be used as an external door lock. It cannot be exposed to direct rain/wet weather. It can be installed on an outside door provided it has adequate partial or full cover so water does not leak into the keypad. The ...

• Z-Wave Lock - Optimal polling interval for the control module

  Manufacturer recommends maximum polling interval during setup of the lock device: 10800s polling This will minimise the time the lock connects to the Z-wave module and maximum the lock battery performance.

• Lock-S Manual / User Guide

  KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

• ETouch Lock - How to change the Motor

  Know your Handle orientation  Refer to the picture below and see if you have a left handle lock or a right handle lock                               LEFT                                          RIGHT Unscrewing unscrew the screws marked on the ...