ETouch Lock - Program/Delete Remote Controller to the Lock

ETouch Lock - Program/Delete Remote Controller to the Lock

How to Add a remote controller

Tap the keypad and press the following:

* 1 2 3 1 2 3 * 6 *

a BLUE or GREEN LED emits and now entered into remote controller programming mode.

Press the button once on the remote controller to program.

You will get a BLUE or GREEN LED on the lock and tone for confirmation. You may enrol up to 8 remote controllers.

How to Delete a remote controller

Tap the keypad and press the following: * 1 2 3 1 2 3 * 7 * during the key sequence, a RED light and a long beep will sound. This indicates that the programming is successful.

* 1 2 3 1 2 3 * 7 *

during the key sequence, a RED light and a long beep will sound. This indicates that the programming is successful and you have removed ALL remote controllers from that lock.

Information about remote controller

  • You cannot remove individual remote controllers.
  • Some models can accept remote controllers and some models will not. It depends on the model number you have purchased. Contact KAS to confirm.

Please be advised this information and more can be found in the Etouch User Manual. This can be downloaded HERE.

 

 

    • Related Articles

    • ETouch Lock - Program/Delete Master Programming Code

      How to Program master programming code This is the highest authority and has the ability to open the lock and change/remove any other pin code, card, FOB or remote.  It can only be altered by completing the following step or completing a FACTORY ...
    • Lock-S Manual / User Guide

      KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...
    • ETouch Lock - Program or Delete an RFID Card/FOB

      How to Add a RFID key card or FOB Conduct the following steps to enrol RFID key cards or FOBs to the lock.  You can enrol up to 80 RFID keycards or FOBs.  Assume master programming code is default: 123123. If you do not need to replace individual ...
    • ETouch Lock - Series 820~850 Cheat Sheet

      Programming Guide This article is a compacted user guide. Please see full manual for further instructions and information Notes: To wake the etouch series lock you need to tap (wake up) the LED display with the palm of your hand. *[MANAGEMENT PIN ...
    • Lock-S Software Neo - Factory Reset

      These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...