ETouch Lock - Keypad is not Waking Up (no lock response even after power cycle)

ETouch Lock - Keypad is not Waking Up (no lock response even after power cycle)

If you are touching the eTouch lock with your palm and the keypad is not waking up and if you have reset the lock and replaced the batteries multiple times, your device could be in bootloader mode.

To get the lock out of bootloader mode all you have to do is update with the latest firmware. You only have to do this once.

Go to this article to update the firmware inside the lock.

    • Related Articles

    • Power Cycle NEO lock/ACR, Platinum lock, Gateway

      Power Cycle NEO Lock 1) Take only one battery out from the back. 2) Put your palm or four fingers and hold it on the keypad/face of the lock. 3) Now put the battery back in while holding the palm/fingers on the face. 4) Let go palm/fingers from the ...
    • Lock-S Manual / User Guide

      KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...
    • Lock-S Software Neo - Factory Reset

      These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...
    • ETouch Lock - Program/Delete Master Programming Code

      How to Program master programming code This is the highest authority and has the ability to open the lock and change/remove any other pin code, card, FOB or remote.  It can only be altered by completing the following step or completing a FACTORY ...
    • Neo Cloud Lock - Error 'keypad light not coming up'

      If your NEO locks keypad not lighting up, it could be because of 2 following reasons. 1) your NEO lock battery is completely dead, please try changing the batteries of your lock and try again. If you are locked out and unable to access the room from ...