Instructions

If you need to program room door Click Here

• The correct cards must be created from the software before you can begin programming the Access Control.
• Always take a back up of your software before programming locks.

1. System Card *If you hear a low to high swoosh sound. please tap the card again. .You need to hear the chime
   
   • Swoosh = Factory Reset
   • Chime should be herd
2. Layer Card 1
   
   • Note this is a special card, usually kept with management. A standard guest card will not work
   •  Select the Option: Storage area occupied by ( not required on A90 version)
3. Layer Card 2*
   
   • For Access Control: Select Controller and select the appropriate option.
   • For a Battery operated lock used for common access: Select Gate and select the appropriate option.
4. Program Card
   
   • wait 3 seconds or until lights stop flashing
5. Clock Card
   
   • Test the guest card. If the door opens successfully then your lock is now programmed.
   • Note: This is a stamped time on the card and will put the same time on the lock as when it was created
6. Now at the lock, you want to program
   
   • Tap the cards over the lock in the order it was created.

Troubleshooting

• • • Ensure the lock presents a chime nose. This means the information has bee received correctly.
    • If you don’t receive a chime when the card is presented, check the card at the software to see the correct card has been issued
    • Wait 3 seconds after the programming card to set the clock