Access Control - How to Factory Reset

Access Control - How to Factory Reset

If you are instructed to complete a 'Factory Reset'. Please conduct the following steps:

By System Card

  1. Locate the original System Card used to initially program the door. Note: you cannot use the PDA.
  2. Swipe the System Card once -> Red LED with a rising tone
  3. Swipe the System card again -> Green LED with a single beep
  4. The lock is now factory reset, all cards will not be invalid.

By Reset Switch

  1. Remove the access control cover from the wall.
  2. Press the White SWITCH on the board
  3. Continue pressing the SWITCH until you hear the lock respond with a low to hi chime.

Result

  • The lock is now factory reset, all cards/pin codes will now be invalid.
  • all data and has been cleared from the device
  • In order to get the lock working, you will need to reprogram the door
  • If you are using Bluetooth, you will need to re-active the Lock using the Lock Keeper App and set the room number again. Go to the 'Setup' tab in the Lock Keeper App.

    • Related Articles

    • Neo ACR & Neo Cloud Lock - User Guide for Local Management

      Preface Local Management and programming (as per below) are not required if you are managing locks access via the mobile App or via a Web Console. Please Note: Battery operated Neo Locks are not recommended for use as "Common Doors". Get the Free App ...

    • Universal (Adel) Access Control - Program an Adel Access Control or Universal Lock as a Common Door

      Instructions Issue the appropriate cards from the software for the Access Control you want to program. If you need to program room door Click Here The correct cards must be created from the software before you can begin programming the Access ...

    • ETouch Lock - Factory Reset

      How to Conduct a Factory Reset Complete the steps to factory reset the master programming code. When the lock will be in factory reset, the management pin code default of ‘123123’. All other programmed data will NOT be deleted. Open the battery cover ...

    • Platinum Lock - Factory Reset

      By System Card Locate the original System Card used to initially program the door. Note: you cannot use the PDA. Swipe the System Card once -> Red LED with rising tone Swipe the System card again -> Green LED with a single beep The lock is now ...

    • Lock-S Lift Control

      Designate card access to assigned floors Specifications  Wiring Diagram ​ Function Guest cards can only access the permitted floors by swiping the card. Example: If the room is on the third floor, the guest can only reach the third floor. When ...