LMS Software - "Data is half-baked incept" Error Message

LMS Software - "Data is half-baked incept" Error Message

Experiencing Fault

Data is half-baked incept when trying to upload the data

How to resolve

  1. Close the software
  2. Disconnected the encoder and mobile programmer
  3. Reconnect the encoder ONLY
  4. Open the software and log in
  5. Issue any card
  6. Read this card. *You can erase this card now
  7. Connect the Mobile Programmer and Upload Data

Reason for Fault

The reason for this message is that the Encoder and Mobile Programmer have lost their association to each other, this may occur for several reasons, most commonly if the mobile programmer has not been used in a while. Once the Encoder is used, then the mobile programmer updated the link is restored.


    • Related Articles

    • LMS Software - How To Read The Unlocking Records from LMS Lock

      Reading the Records from an LMS Lock Take the mobile programmer to the lock you wish to collect the records from       1)      Press 2       2)      Press RUN       3)      Hold to lock induction area, you might have to adjust the position of the ...
    • LMS Software - User Manual

      Full User Manual and Quick Reference Guide
    • LMS Software - How To Upload Data To Your Mobile Programmer

                  1)  Plug Programmer into the computer using the USB-encoder's cable.       2)  Open LMS Software       3)  Select Upload Data (top left of page)       4)  Select Download Lock Data       5)  Wait for confirmation message       6)  Once ...
    • LMS Software - How To Upload Data To Your Mobile Programmer

            1)       Plug Programmer into the computer using the USB-encoder’s cable.       2)      Open LMS Software       3)      Select Upload Data (top left of page)       4)      Select Download Lock Data       5)      Wait for confirmation message ...
    • Lock-S Software - "Fail to write" PDA error message

      If you are getting the "Fail to write" message, this may indicate the PDA has not been configured correctly for the site software. Please try the following: Plug PDA into the computer through supplied USB->USB micro cable Click System>PDA from top ...