Lock-S Software - Set "Auto-Open" time on a Common Door Lock

Open your KAS Lock-S software and click on data >> common door 

Click on the lock that you want to set the "Auto-Open" time for and click edit.

Now on the next screen click on the little box that say Auto Open and set your desire time and click Save.

Now connect your PDA to the PC using a USB cable and on the Lock-S software click on System >> PDA

Then on the next screen click on the tabs in the right order as shown below.

After that disconnect your PDA from the PC and on the PDA screen click on Passage

From the List choose your Lock name that you are setting the Auto Open time for.

After selecting the Lock name there will be a little dialogue box appear on the screen as follows. while that dialogue box is on the screen tap the PDA on the face of the lock.

Do not press "OK" before tapping the PDA on the lock. please start the process from Step if you 

After pressing OK there will be another dialogue box as shown below tap the PDA on the lock again and press OK again.

Do not press "OK" before tapping the PDA on the lock.

From the Front screen click on Clock

When you see the following screen on the PDA tap it again on the lock.

To refer to the video on how to program the lock using PDA please click here

• Related Articles

• Lock-S Manual / User Guide

  KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

• Lock-S Software Neo - Factory Reset

  These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...

• Lock-S Software - Difference between "Auto Open" and "Open Time"

  Auto Open The lock will be in 'free passage' between these hours. No card required. Outside these hours, all valid cards will access the lock Open Time The lock will allow all valid card access* between these hours After this time no card will access ...

• Universal (Adel) Access Control - Program an Adel Access Control or Universal Lock as a Common Door

  Instructions Issue the appropriate cards from the software for the Access Control you want to program. If you need to program room door Click Here The correct cards must be created from the software before you can begin programming the Access ...

• Lock-S Program Lock Hardware

  Preface Programming the lock hardware can be completed by either of these 2 methods. Via cards or using the PDA These instructions for the Platinum Lock, Neo Lock and Access Controls on the Lock-S software Methods 1. Card Programming The card method ...