ETouch Lock - Program/Delete Master Programming Code

ETouch Lock - Program/Delete Master Programming Code

How to Program master programming code

This is the highest authority and has the ability to open the lock and change/remove any other pin code, card, FOB or remote.  It can only be altered by completing the following step or completing a FACTORY RESET. Default master programming code is: 123123

Tap the keypad and press the following:

* 1 2 3 1 2 3 * 0 * 9 9 9 9 9 9 *

This will change the program management pin code from ‘123123’ to ‘999999’

 

Please be advised this information and more can be found in the Etouch User Manual. This can be downloaded HERE.

    • Related Articles

    • Lock-S Manual / User Guide

      KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

    • Lock-S Program Lock Hardware

      Preface Programming the lock hardware can be completed by either of these 2 methods. Via cards or using the PDA These instructions for the Platinum Lock, Neo Lock and Access Controls on the Lock-S software Methods 1. Card Programming The card method ...

    • ETouch Lock - Program or Delete an RFID Card/FOB

      How to Add a RFID key card or FOB Conduct the following steps to enrol RFID key cards or FOBs to the lock.  You can enrol up to 80 RFID keycards or FOBs.  Assume master programming code is default: 123123. If you do not need to replace individual ...

    • ETouch Lock - Program/Delete Remote Controller to the Lock

      How to Add a remote controller Tap the keypad and press the following: * 1 2 3 1 2 3 * 6 * a BLUE or GREEN LED emits and now entered into remote controller programming mode. Press the button once on the remote controller to program. You will get a ...

    • ETouch Lock - Factory Reset

      How to Conduct a Factory Reset Complete the steps to factory reset the master programming code. When the lock will be in factory reset, the management pin code default of ‘123123’. All other programmed data will NOT be deleted. Open the battery cover ...