Lock-S Software - "Fail to write" PDA error message

Lock-S Software - "Fail to write" PDA error message

If you are getting the "Fail to write" message, this may indicate the PDA has not been configured correctly for the site software.



Please try the following:
  1. Plug PDA into the computer through supplied USB->USB micro cable
  2. Click System>PDA from top menu bar
  3. On the 'PDA' screen click the following buttons
    1. Clear PDA
    2. Init PDA
    3. Download Data
    4. Clock
  4. If you do not get a 'Successful' message on all of the buttons. Try clicking the button again.

 

This has reconfigured the PDA for the software.

    • Related Articles

    • Lock-S Software Neo - Factory Reset

      These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...

    • Lock-S Manual / User Guide

      KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

    • Lock-S Program Lock Hardware

      Preface Programming the lock hardware can be completed by either of these 2 methods. Via cards or using the PDA These instructions for the Platinum Lock, Neo Lock and Access Controls on the Lock-S software Methods 1. Card Programming The card method ...

    • Lock-S Software - Error "Fail to open serial Port"

      If this image is displayed, this means the encoder (card write cannot be found by your computer) Please check the following: Check the cable connection from the encoder to the computer Close and reopen Lock-S software Try to issue a card If this does ...

    • Lock-S Software - Checking Firmware Version of the Locks via PDA

      Connect your PDA via USB cable with the PC and click on System >> PDA on the KAS lock-S system software. Now Click Clear PDA >> Init PDA >> Download Data >> Clock  as shown below in the right order. Now Disconnect the PDA from the PC and click the ...