Lock-S Software - "Invalid system clock" Error when Opening the software

If you see the error below please follow the steps

Step # 1:

Click OK and you will be able to see the screen below

Step # 2:

Copy and paste the license key showing above into the blocks below and click OK.

Step # 3:

Click Exit.

Step # 4:

Reopen the software.

• Related Articles

• Lock-S Software Neo - Factory Reset

  These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...

• Lock-S Manual / User Guide

  KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

• Lock-S Software - How to set the CLOCK by RFID Card

  Issuing a CLOCK card Open Lock-S Software Go to Clock Card under Setting Cards Put a blank card on the card encoder Click Issue Swipe the Clock card on the lock once. Tips: Ensure the time you have programmed onto the clock card is the same as the ...

• Lock-S Program Lock Hardware

  Preface Programming the lock hardware can be completed by either of these 2 methods. Via cards or using the PDA These instructions for the Platinum Lock, Neo Lock and Access Controls on the Lock-S software Methods 1. Card Programming The card method ...

• Lock-S Software - Error "Fail to open serial Port"

  If this image is displayed, this means the encoder (card write cannot be found by your computer) Please check the following: Check the cable connection from the encoder to the computer Close and reopen Lock-S software Try to issue a card If this does ...