LMS Software - How To Upload Data To Your Mobile Programmer
1) Plug Programmer into the computer using the USB-encoder’s cable.
2) Open LMS Software
3) Select Upload Data (top left of page)
4) Select Download Lock Data
5) Wait for confirmation message
6) Once complete, disconnect the Mobile Programmer.
7) Close the software
8) Connect the USB Encoder
9) Reopen Software
Encoder will not function if you do not close the software and reopen after you have disconnected the mobile programmer.
Related Articles
LMS Software - How To Upload Data To Your Mobile Programmer
1) Plug Programmer into the computer using the USB-encoder's cable. 2) Open LMS Software 3) Select Upload Data (top left of page) 4) Select Download Lock Data 5) Wait for confirmation message 6) Once ...LMS Software - "Data is half-baked incept" Error Message
Experiencing Fault Data is half-baked incept when trying to upload the data How to resolve Close the software Disconnected the encoder and mobile programmer Reconnect the encoder ONLY Open the software and log in Issue any card Read this card. *You ...LMS Software - User Manual
Full User Manual and Quick Reference GuideLMS Software - How To Read The Unlocking Records from LMS Lock
Reading the Records from an LMS Lock Take the mobile programmer to the lock you wish to collect the records from 1) Press 2 2) Press RUN 3) Hold to lock induction area, you might have to adjust the position of the ...Lock-S Software Neo - Factory Reset
These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...