ETouch Lock - Installation & Setup

ETouch Lock - Installation & Setup

Installation and Setup

Lineation

  1. Select your lock height, and place a marking on the door where you want the lock to sit
  2. From this marking, measure out the back set (60mm or 70mm provided with lock)
  3. Measure out the other markings required that are provided on your drilling template
  4. Do this for both sides of the door. You will be later required to drill half way through the front side of the door, then halfway through the backside

Drilling

  1. Drill your 2 marked ‘back to back’ holes. It is recommended to drill half way on each side of the wood to reduce chances of the wood splitting
  2. Drill out the latch hole on the side of the door
  3. Place your latch in the hole on the door edge and mark around the faceplate
  4. Chisel out the faceplate markings from your door. This is required to be 3.5mm deep

Lock Installation

  1. Take your latch and place it in the pre-drilled hole [Image A]
  2. Screw it into place with the 2 screws provided.
  3. Ensure the rubber gasket cover is on both sides of the locks
  4. Take the front handle and place it on the door, ensuring all screws and holes line up.
  5. Place the wires from the lock through the rubber gasket and through door hole to ensure no pinching of the wires and a flush covering [Image B]
  6. Insert spindle into the front handle ensuring it is inserted into the lock properly.
  7. Spring end is at the back of the lock.
  8. Please ensure a firm fitting of the spindle to the electronic clutch hole.
  9. Place the Back plate frame onto the back of the door and screw into place [Image D]
  10. Connect and line up the back handle to fit the spindle, screw into place (spring should be to the back of the lock)
  11. Gently connect the wire together [Image C]
  12. Place the back handle onto the metal frame; screw the 2 screws at the base of the lock and 1 screw in the battery pack area. [Image D]
  13. Insert batteries
  14. Your lock is now ready for programming - See Programming article for instructions. *Please keep the mechanical back up keys in a safe and secure location in case of battery depletion.

                     


VIDEO



 

 


    • Related Articles

    • Lock-S Manual / User Guide

      KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...

    • Lock-S - Backing up your database

      Premise In the event of a property handover or as part of your backup routines, the Lock-S database can be backed up to prevent a total system lockout. This ensures that in any event, you will be able to restore your database on a new computer and ...

    • Neo Cloud Lock - Hardware Installation Guide

      Preface Electronic locks are sensitive and advanced products with fragile microchips and hardware. Please be aware that the position and type of environment the lock is installed in can affect its lifespan. To install the lock, we recommend ...

    • Platinum Lock - Hardware Installation

      <br> Note: If the lock is meant to be used with KAS Access - It is the job of the installer, as part of the installation process, to pair the lock to the customer's account and name it with an easily recognizable name (e.g. the unit number) 1) ...

    • ETouch Lock - Factory Reset

      How to Conduct a Factory Reset Complete the steps to factory reset the master programming code. When the lock will be in factory reset, the management pin code default of ‘123123’. All other programmed data will NOT be deleted. Open the battery cover ...