ETouch Lock - Factory Reset
How to Conduct a Factory Reset
Complete the steps to factory reset the master programming code. When the lock will be in factory reset, the management pin code default of ‘123123’. All other programmed data will NOT be deleted.
- Open the battery cover on the inside of the door.
- Hold the default switch in the back plate for 3 seconds.
- LED will illuminate and a ‘beep…’ sound will be heard.
Lock is Factory Reset
Please be advised this information and more can be found in the Etouch User Manual. This can be downloaded HERE.
Related Articles
Lock-S Software Neo - Factory Reset
These Instructions are only for the Neo Lock when managed from the Lock-S software. Please revisit the knowledge base if you are looking for instructions on the Standalone/ Cloud-managed Neo Lock By System Card - Hotel mode only you cannot use the ...
Platinum Lock - Factory Reset
By System Card Locate the original System Card used to initially program the door. Note: you cannot use the PDA. Swipe the System Card once -> Red LED with rising tone Swipe the System card again -> Green LED with a single beep The lock is now ...
ETouch Lock - Program/Delete Master Programming Code
How to Program master programming code This is the highest authority and has the ability to open the lock and change/remove any other pin code, card, FOB or remote. It can only be altered by completing the following step or completing a FACTORY ...
ETouch Lock - Series 820~850 Cheat Sheet
Programming Guide This article is a compacted user guide. Please see full manual for further instructions and information Notes: To wake the etouch series lock you need to tap (wake up) the LED display with the palm of your hand. *[MANAGEMENT PIN ...
Lock-S Manual / User Guide
KAS Lock-S Hotel Card Lock Software Module Introduction The KAS Lock-S Software must be activated with Serial number and Product ID. The authorized client must safeguard the unique Product ID assigned. An authorized person should be assigned to take ...