Changing Lift Floor Control - With the Lift Running Card

Changing Lift Floor Control - With the Lift Running Card

Function

This function allows you to control the floors a staff or guest has access to.

Free Floor 

  • *This is noted in the software as Pink Box
  • Allows any lift user access to the floor. eg Ground Floor and/or Basement etc

Controlled Floors

  1. *This is noted in the software as White Box
  2. Only appropriate cards/ credential holder will have access to this floor. eg Guest Room Floors

Process

  1. On the top drop-down menu: Lift System Management  > Make Lift Running Card. 
  2. You will see all the floors available to control.
    • Double click on the floor numbers you want to have free and controlled
      • Free Floor - *This is noted in the software as Pink Box
      • Controlled Floors -*This is noted in the software as White Box
  3. Once you have selected your controlled & free floors select Issue Card
  4. Take this card and tap it on the lift. The reader will sound an alert to say the update has been completed

Helpful Hint

  • You can create multiple Lift Running Cards for different access when required and leave in a safe place
    • Make sure you label the cards appropriately
    • Just tab the card over the reader to alternate between the different Lift Running Cards
  • These cards do not expire. You can delete from the software or re-write on them

    • Related Articles

    • Lock-S Lift Control

      Designate card access to assigned floors Specifications  Wiring Diagram ​ Function Guest cards can only access the permitted floors by swiping the card. Example: If the room is on the third floor, the guest can only reach the third floor. When ...

    • Lift Call

      Reader: The following readers can be used for Lift Call: Standard Access Control Reader Bluetooth Access Control Reader (mobile phone can call the lift)   Wiring: Installation: Install the Access Control relay contacts (NO, NC, COM) on the lift ...

    • LMS Lift Control Module - Manual

      Introduction Used in conjunction with the LMS-Software & the LMS-Access Control System The lift control system is used to control the floors the use can access This control can be pre configured and selectable options at the time of checkinn Example ...

    • Lock-S Relay Module RM - Wiring and Programming Lift Controller RM

      This document is intended for Electrical Installers only.  Information contained herein is intended as a guide for suitably qualified Lift Controller Installers.  The ACR should be wired to the RM with the ACR Brown wire connected to the RM RS485 A+ ...

    • Neo ACR & Neo Cloud Lock - User Guide for Local Management

      Preface Local Management and programming (as per below) are not required if you are managing locks access via the mobile App or via a Web Console. Please Note: Battery operated Neo Locks are not recommended for use as "Common Doors". Get the Free App ...