Program or Delete a User pin code

Add a User pin code

You should enter your personal programming code whilst conducting the following steps.  Note: this assumes your master programming code is 123123.

Wake up the keypad and press the following:

* 1 2 3 1 2 3 * 1 *

during the key sequence, a RED light and a long beep will sound. This indicates that you have entered programming mode for user pin codes ‘1’.

Enter your personal pin code (7452 as an example) and press *:

7 4 5 2 *

A confirmation tone will sound.

You may enter up to 8 pin codes and they can be between 4 and 6 digits.

To test the pin code: Tap the keypad and press 7 4 5 2 * a BLUE or GREEN light will show if successful. If a RED light followed by a few short beeps happens, try to program the pin code again.

Delete ALL user pin codes

Tap the keypad and press the following:

* 1 2 3 1 2 3 * 2 *

during the key sequence, a RED light and a long beep will sound. This indicates that the programming is successful.

Note: you can only remove ALL user pin codes at once. You cannot remove individual pin codes.

Please be advised this information and more can be found in the Etouch User Manual. This can be downloaded HERE.

Was this article helpful?

Related Articles

Leave A Comment?