‘Data is half-baked incept’ message

Data is half-baked incept when trying to upload the data

If this message appears

  1. Close the software
  2. Disconnected the encoder and mobile programmer
  3. Reconnect the encoder ONLY
  4. Open the software and log in
  5. Issue any card
  6. Read this card. *You can erase this card now
  7. Connect the Mobile Programmer and Upload Data

The reason for this message is that the Encoder and Mobile Programmer have lost their association to each other, this may occur for several reasons, most commonly if the mobile programmer has not been used in a while. Once the Encoder is used, then the mobile programmer updated the link is restored.

Was this article helpful?

Leave A Comment?